Professional supplier of press feeders!
What are the maintenance steps for a faulty clamp feeder?
Sep 10,2025
The clamp type feeder is an indispensable equipment in light and heavy industries. The feeder is a machine that uses the power of machine motion to move and transport materials. What are the maintenance steps after a feeder malfunction?
Maintenance steps after feeder malfunction:
1. Check the signal source of the feeding machine control alarm system.
Is there any spark, lighting fixture, abnormal noise, abnormal heating, or anxious burning smell in the feeder malfunction. Carefully observe the surface condition of each printed circuit board for any signs of burning or damage. The alarm light displays a fault, and modern computers send information to the numerical control system, which is distributed on the power supply, servo drive, and input/output devices. Based on the alarm light, the cause of the malfunction can be determined, further narrowing down the scope of inspection. This is a relatively basic and commonly used method.
2. Check if there are any issues with the surface of the feeding machine equipment.
When operating, it is important to strictly prevent iron blocks, large hard objects, etc. from entering the groove. Check whether the chain pin is broken or loose, and replace or repair it in a timely manner; Check if the scraper is damaged or worn. If there are any bent, deformed or lost scrapers, they should be replaced or repaired in a timely manner. Scratches or grooves on the polyethylene scraper may indicate other issues. Regularly remove hemp ropes and other debris from the feeding machine to avoid motor overload and damage to the motor and reducer after winding the chain.
3. Single piece inspection of the feeding machine.
When you don't know where the problem lies. Accessories can be checked separately. For example, when the servo system operates independently, it only depends on whether the light screen is displaying properly. Is there an alarm, etc. Whether the pressure on the feeding roller of the feeder is insufficient or whether the roller is loose can only be gradually and orderly discovered as equipment problems.
Hot Tags:
Contact Us
E-mail:
gsw@chfeeder.com
Phone/WhatsApp:
+86-13751226330
Address:
Jiangnan Village, Gaoqiao Town, Haishu District,
Ningbo City, Zhejiang Province